產品分類

products category

技術文章/ article

您的位置：首頁 - 技術文章 - 匈牙利品牌FAKOPP 用于測量軀干的產品木材應力波微秒計Microsecond Timer

匈牙利品牌FAKOPP 用于測量軀干的產品木材應力波微秒計Microsecond Timer

更新時間：2024-04-11

瀏覽次數：808

匈牙利品牌FAKOPP 用于測量軀干的產品木材應力波微秒計Microsecond Timer

以微秒為單位測量傳輸時間

非常快

一天中甚至可以測量100棵樹

探測更大的衰變，空穴

Measures the transit time in microseconds

Very fast

Even a 100 trees can be measured during one day

Detects the bigger decays, holes

Fakopp Microsecond Timer

Connect the transducers to the timer box.
Switch on the timer. Before each hit please press the
“Reset" button. If you want to use the auto reset function,
switch on the timer while the “Reset" button is held down.
In this case the actual readout appears on the screen after
each hit without pressing “Reset".
Transducers are identical. Please select the transducer, connected
to the ?Start" connector. A colour mark helps you to identify the
start transducer. Hit the start sensor by using hammer. The hit
should always be parallel with the direction of the nail. Use a rubber
hammer for driving in the sensors. For the measurement use a 100 g
steel hammer. Let the hammer spring back. After use, switch off the unit.
將傳感器連接到計時器盒。打開計時器。每次點擊前請按下“重置"按鈕。
如果您想使用自動重置功能，請?jiān)诎醋　爸刂?按鈕的同時打開計時器。
在這種情況下，實際讀數會在每次點擊后出現在屏幕上，而無需按下“重置"。
傳感器是相同的。請選擇連接到“啟動"連接器的傳感器。彩色標記有助于
識別啟動傳感器。用錘子敲擊起動傳感器。擊打方向應始終與釘子的方向平行。
使用橡膠錘敲入傳感器。使用100克鋼錘進行測量。讓錘子的彈的回來。使用后，
請關閉設備。